220V Instantaneous Electric Water Boiler | Household Tap Faucet Warmer with Thermostat for Kitchen

Product features:

The small heating block is simple and convenient to install, and is suitable for installation in the kitchen, bathroom, shower, public bathroom, etc. It is suitable for ordinary washing, washing hands, dishes, dishes, washing faces, and bathing. The tempeure range is between 20-50 degrees. The tempeure is controlled by the size of the water flow. The water flow is large and the tempeure is low, and the water flow is small and the tempeure is high. The Fahrenheit and Celsius modes can be set to . Under the startup status, long press the startup on for more than 6 seconds, and the mode can be ed

Specification:
Material: Stainless Steel Shell
Color: Black, Orange, Red, Blue,White(optional)
Power: 3000W/3500W
Voltage: 110V /220V（Optional）
: / us / AU / (Optional)
ed Frequency: 50Hz
ed Pressure: 0.4-0.6Mpa
Waterproof Grade: IPX4
Tempeure: 30-45℃(Considering the use environment in severe cold areas may not reach the maximum tempeure of 55℃)
Installation wire diameter: ≥2.5mm² copper wire
Water interface: G 1/2" interface
Size: 24 × 17.5 × 15.5cm / 9.45 × 6.89 × 6.10 inch (appr.)

"About the installation and use of the mini water

Requirements for installation environment: kitchen, toilet, toilet, shower room, electric wire shall be more than 2.5 square meters; The circuit breaker is greater than 32 A;

Common faults and handling methods:

1. Check whether the power supply is normally powered on. The indicator light on the power-on display will show the tempeure, but it will not light up if it is not powered on.

2. Under normal power-on condition, the water flow is turned on, press the key on, the machine starts heating, and the water displays: water outlet tempeure 3. If the tempeure does not rise, there are two possibilities: one is that the tempeure control (overheat protection ) inside the water jumps, and press the tempeure control once to recover The other is the heating failure, which can be replaced

4. If there is a display that does not heat up, and the display lamp turns around, it means that the water flow does not p through the water , or the water pressure is too low, or the installation direction is wrong. Pay attention to the correct installation of water inlet and outlet. But if the water pressure is enough, and there is water flow that does not heat up, then check the turbine at the water inlet of the water . It may be that something dirty is blocking the turbine, causing the water to not start

5. It is recommended that the length of the water outlet of the water should not exceed 3 meters. If the length of the water outlet exceeds 3 meters, there may be water pressure difference due to the length of the water . If the water pressure is not enough, the water can not be started (If the water tower is used in rural areas, the height of the water tower is required to be higher than 10m to make the water pressure reach the starting value)

6. The display screen shows E1 overtempeure, E3/E4 or tempeure sensor failure. First cut off the power, p the machine through with cold water, and then use it when powered on. Pay attention to the use of water flow not too small

7. The heating tube fault displays E2, and the heating tube needs to be replaced“

Package Included:
1 x Water

Note:

1. This product must be installed vertically.
2. Before using the machine, first turn the water on and then power on. Avoid damage.